Samsung Laser Printer Samsung Printer Error Codes And How To Fix

There have been several models of laser printers Samsung has launched. However, many of them seem to pose varying degrees of problems. Here are some common error codes and troubleshooting tips:

Error message: Scanning error

This error is primarily a hardware failure. You can try replacing the USB cable. Sometimes poor quality cables can not transmit important data required by a scanner.

Error message: Paper jam

This happens when paper is jammed in the laser printer from Samsung. You need to check the sensor next to the exit rollers. Perhaps it is a position error, or is damaged. If nothing works, try replacing it with a new sensor.

Error: Press Square

Sometimes you may find that your Samsung laser printer print squares instead of plain text. This can happen if you use Firefox or print the contents of sites that do not recognize the font used in the text. To resolve this problem, you need to reinstall all drivers. If this does not help, you can visit the Printers and Faxes folder, select your printer and select Properties.

Error message: no printing

Sometimes part of your page without pressure. This can happen because the setting of paper size incorrect. Check the settings and try again.

Error Code: H2

This error code indicates a problem with the heating of the fuser. Make sure all cables are connected and no point is missing.

Error message: empty tray

Sometimes, even if the tank is filled with paper, you can get this error message on your Samsung laser printer. Try updating the drivers, visit the Samsung website. That should fix it.

Error: Toner light still on

When replacing the toner cartridge you might still find the toner light constantly. You need to check the fuse located on the front of the cartridge. You could try to replace these 50 mp one. This error usually occurs in the Samsung SCX-4216F.

Error Code: 24

This error code indicates that there is too much work because the print job is concerned. You can select the "Continue" button, and then try to reduce the amount of print job.

Error Code: 50

This indicates a fault in the fuser. This means that the merger is not hot. Try switching off your Samsung laser printer or reset the printer for about 15 minutes, then turn it on. If this problem persists, it may indicate a bug in the oven or food.

Error Code: 16

This error code means that the toner is low. This means that the distribution of toner inside the cartridge is inadequate. You have to make the cartridge and gently move it front and back. If this does not work try replacing the cartridge. You could also try cleaning the contacts.